+ Post New Thread
Page 21 of 118 FirstFirst ... 11 19 20 21 22 23 31 71 ... LastLast
Threads 401 to 420 of 2341

Forum: 380 DB Series I - Series III

380 owners from DB 2005 - DB SIII 2008 Discussion here.

  1. Aftermarket boss kit and steering wheel HELP

    Hey I am in need of an aftermarket boss kit to support the mitsubishi 380, I prefer something quick release and genuine only, im not any chinese crap fake counter fit parts. Does anyone know what kind of boss kit i can get, if the 380s have the same diameter centre part thingy as the pajeros??...

    Started by freshi, 22-07-2014 10:53 AM
    • Replies: 8
    • Views: 1,905
    25-07-2014 07:15 AM Go to last post
  2. Please help me reset my 380 alarm!

    Hi all I have a 2006 380. In the last week, something has gone wrong with the alarm. When I unlock with the key, it is meant to unlock the drivers side and deactivate alarm and on second press, unlock the other doors. When I press the button now, no matter how many times, it just unlocks the...

    Started by Megan, 24-07-2014 08:47 AM
    • Replies: 1
    • Views: 634
    25-07-2014 04:05 AM Go to last post
  3. heater fan no worky

    It seems the climate control fan has died on the VRX, there is heat being produced but no fan on any seeing. Sounds like the fan speed controller?

    Started by genebaby, 09-07-2014 10:51 AM
    • Replies: 2
    • Views: 800
    16-07-2014 07:20 PM Go to last post
  4. RPW Header

    Hi Guys, First the good news. I took my 380 to Liverpool exhausts and they put on a new rear pipe (Hurricane). They also attached 3 small brackets near the weld and flange area to add some support. They then did the same to the old pipe and gave them to me as well. I was ovewhelmed when they...

    Started by kevinm, 04-07-2014 10:16 AM
    • Replies: 5
    • Views: 1,756
    05-07-2014 07:25 PM Go to last post
  5. 6g75 vs 6g75 mivec need advice on build

    Hey im starting on my engine build.... Ive been talking about it for a while....Now my guns are loaded ready to go.... Is there much work and worth while going to a mivec 6g75? and how easily can i get a mivec block? Or would i be better just modding the non mivec block? Im going...

    Started by freshi, 02-07-2014 02:25 PM
    • Replies: 4
    • Views: 1,264
    04-07-2014 06:59 AM Go to last post
  6. Engine mount drivers side worn.

    Anyone tell me whether it is best to replace all engine mounts if one goes ? Have a 380 series 2 vrx with 156k's on the clock. There is a knock on the drivers side front and I was told it was better to do all the mounts if one goes or could I just stick the drivers side in and is it a big job ?

    Started by 380nanny, 02-07-2014 02:42 PM
    • Replies: 1
    • Views: 723
    02-07-2014 02:51 PM Go to last post
  7. Electrical problems. Is this the beginning of a trend as they get on in years???

    Well I am starting to think that electric problems seem to be the 380's archilles heel. Well engineered and reliable from a drivetrain, suspension, brake, body point of view. However, I wonder how much Mitsubishi tried to save in electrical parts? The really important parts like ABS/traction...

    Started by steve_bunkle, 03-01-2014 09:20 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 3,451
    01-07-2014 05:41 PM Go to last post
  8. Oil leaking from spark plug holes...need help

    Oil leaking from all 6 spark plug holes, all of them about 3cm deep in oil, No smoke blowing from exhaust, not down on power, plugs are NGK BKR5EIX-11 changed at 135,000kms car has about 180,000kms.... Has anyone had this problem and know what causes it? Inside spark plugs are in ok-good...

    Started by freshi, 24-05-2014 04:16 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 4,923
    01-07-2014 10:05 AM Go to last post
  9. 380 power steering fluid....type of oil

    Hey all, its time to flush out my power steering fluid, Does anyone here use the castrol ATF DEX III for there power steering fluid and any cons about it? I have half a bottle of the oem mitsubishi power steering fluid left.... the castrol and nulon are a HEAP HEAP thinner almost like water...

    Started by freshi, 25-06-2014 12:49 PM
    • Replies: 1
    • Views: 863
    26-06-2014 09:29 PM Go to last post
  10. Help

    I am happy with my TJ Advance and love Mitsubishi. Now comes the issue. I am tempted to buy a 380. Input and ideas welcome. I have been looking at some SX 380s. Does the SX have same suspension and sport seats as VRX and GT. There is crazy info out there and I know you guys will have the facts....

    Started by dickie77, 18-06-2014 09:12 PM
    • Replies: 2
    • Views: 642
    19-06-2014 07:08 PM Go to last post
  11. 380 Brake pad recommendations??

    Hi, our 380 suffered from some brake fade today...its never had really sensitive brakes, but have only owned it 6 months, can anyone recommend pad type/brand?? Il change fluid etc which is no issue..and pads to another type.cheers

    Started by demenace, 24-05-2014 04:52 PM
    • Replies: 3
    • Views: 1,325
    15-06-2014 08:42 AM Go to last post
  12. Interchangeable bumpers

    Anybody have an idea if a series III vrx front bumper (updated air dam) will fit onto a series II vrx? There's a few discussions about how to remove bumpers etc but I haven't found anything regarding if the bumpers of the different series are interchangeable. I'd assume they are as I can't see...

    Started by ocnav, 13-06-2014 04:57 PM
    • Replies: 2
    • Views: 651
    15-06-2014 08:09 AM Go to last post
  13. CEL Code P0031 need help ASAP!!!!

    Check Engine light P0031 What does it mean? and which sensor would it be?? Mitsubishi 380 vrx 5 speed manual 2005 Thanks

    Started by freshi, 10-01-2014 03:51 PM
    • Replies: 9
    • Views: 2,263
    14-06-2014 12:23 PM Go to last post
  14. Hydraulic lifters rattling (not timing tension er)

    So after i thought i had the timing tensioner rattle, we took of timing covers let the engine go bone cold, and re start to listen to the rattle, and turns out it has nothing to do with the timing components but highly likely its the hydraulic lifters, we let it cool again and if we crank 1-2 secs...

    Started by freshi, 13-06-2014 04:26 PM
    • Replies: 4
    • Views: 918
    13-06-2014 06:34 PM Go to last post
  15. Strobe gear shift lights

    Hi all. I've read threads on the + and - lights on the gear shift being blown - but has anyone had issues with the rest of the shifter lights flashing almost like a strobe? Just happens when the car isn't moving so I don't think it's a loose connection. Doesn't worry me unless I'm driving at...

    Started by Jonno.lowe, 06-06-2014 07:08 PM
    • Replies: 1
    • Views: 692
    07-06-2014 09:09 AM Go to last post
  16. Heater issues - hot air not shutting off

    Hello I have a mistubishi 380 2005 DB, with around 125,000ks. duel fuel LPG IMPCO unit installed from mitsubishi I have a few annoying issues with this car. mainly outlined below Current issues - LPG cutting out causing CEL - heater not shutting off - dial is at coldest, and i can hear a...

    Started by kon, 05-06-2014 03:56 PM
    • Replies: 1
    • Views: 526
    05-06-2014 04:09 PM Go to last post
  17. CEL error codes, anyone had these codes before need help?

    P2096 Post cat system to lean V1101? V1606? P0830 Clutch pedal switch Ive got livo exhaust headers, 200cell metal hi flow cat, custom exhaust, kn filter, NEW OEM o2 sensors with correct custom length wires, I done this all same time, code never came on for about 3months straight, now its...

    Started by freshi, 04-06-2014 05:01 PM
    • Replies: 3
    • Views: 913
    04-06-2014 05:38 PM Go to last post
  18. Trouble with the RPW header

    Hi Guys I was really hoping I wouldn't have to say this. But for the second time the rear RPW header on my 380 has developed a crack. Again it is near the weld and nuts where it joins the block. You may remember the first one lasted around 8 months and RPW replaced it. Now the second has lasted...

    Started by kevinm, 28-05-2014 12:27 PM
    • Replies: 7
    • Views: 1,326
    29-05-2014 07:20 PM Go to last post
  19. 380 aftermarket engine seals (DO NOT USE)...mitshi starting to run out of parts

    After having my camshaft oil seals leak heaps of times now, and now my spark plug tube seals leak, this is due to the aftermarket seals are of a cheaper quality seal and actually not the exact same size as OEM causing me these headaches. It could just be me but im leaning more towards aftermarket...

    Started by freshi, 27-05-2014 08:42 PM
    • Replies: 3
    • Views: 1,154
    28-05-2014 08:09 PM Go to last post
  20. Elliot

    Thanks to all those who've described and added fix-its for the ticking noise in the engine bay of some 380's. The canister purge valve that was described in the replies was the problem in my case. A new replacement is $132 ex Mitsubishi, but a drop and only a drop of WD40 in both ends has fixed the...

    Started by Elliot, 28-05-2014 03:26 PM
    • Replies: 1
    • Views: 1,191
    28-05-2014 06:49 PM Go to last post

+ Post New Thread

Forum Information and Options

Users Browsing this Forum

There are currently 8 users browsing this forum. (0 members & 8 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts